Please Reboot Computer and Start Mining Again

minefewcoins Jr. Member Offline Activity: 34 Merit: 2

Hi, this is my get-go post, so be gentle please. My PC restarts few minutes after I commencement Claymore dual miner (eth-dcr). I tried to limit power draw anywhere from -15% to -50%. Information technology says my power depict from the wall is 700-1150w depending on settings. No matter what settings I put on Wattman information technology restarts every fourth dimension. I tried 2-3  drivers and information technology didn't help. Can you bespeak me in the right direction because I am totally clueless? My rig is: PSU FSP aurum 1200w PT 4x Asus Vega Strix 56 CPU Pentium G4400 MOBO Gigabyte GA-H110-D3A Mining Ready RAM Crucial CT8G4DFD8213 SSD Kingston uv400 Riser card ver.008s

Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction. Advertise hither.

PatM14 Newbie Offline Activeness: 49 Merit: 0	troubleshoot your pc by trying 1 vid carte du jour, so 2, and so iii, so 4. sometimes it possibly some other pc component driving your computer to restart.

minefewcoins Jr. Fellow member Offline Activity: 34 Merit: 2	troubleshoot your pc by trying one vid card, so 2, and so 3, then 4. sometimes it perhaps some other pc component driving your computer to restart. I did. Information technology happens anyhow. But i think I found the trouble. Can you tell me what temps in cherry-red boxes should be?

BaNgTHai Full Member Offline Activity: 166 Merit: 100	Im pretty certain they shouldn't run hotter than 80C

xxcsu

troubleshoot your pc past trying 1 vid card, so two, and so 3, and then 4. sometimes it maybe some other pc component driving your computer to restart. I did. Information technology happens anyway. Simply i think I constitute the trouble. Can y'all tell me what temps in red boxes should be? Don't mine with those cards with 91C avarage temp ... You are killing your cards , your pc probably shut downward bc the thermal protection ? Its maybe just a reading mistake , you should cheque that temp with another software too You should continue that temp under 80C  , better effectually 70C for a 24 hours mining ... If you keep doing what you lot doing you killing your cards within a brusque menses of fourth dimension .... What is telling yous exactly your rig is pulling 700-1150 watts at the wall ? Information technology says my power draw from the wall is 700-1150w depending on settings. Did you lot checked the temps with gpuz also ? What temperature GPU-Z is reporting ?

cpmcgrat Fellow member Offline Action: 226 Merit: 21 DCAB

troubleshoot your pc by trying 1 vid carte, and then 2, then 3, then 4. sometimes information technology maybe some other pc component driving your calculator to restart. I did. Information technology happens anyway. Simply i retrieve I institute the problem. Can you tell me what temps in ruby boxes should exist? Don't mine with those cards with 91C avarage temp ... Yous are killing your cards , your pc probably shut downwardly bc the thermal protection ? You should continue that temp under 80C  , improve around 70C for a 24 hours mining ... If y'all continue doing what you doing you killing your cards inside a short catamenia of time .... What is telling you lot exactly your rig is pulling 700-1150 watts at the wall ? It says my power draw from the wall is 700-1150w depending on settings. If I had to guess it is probably just the ability draw of the cards themselves, not the whole rig. Unless he'southward running it off a battery where the discharge can be measured.

Member, Dero Community Advisory Lath (DCAB)

adaseb Legendary Offline Activity: 3024 Merit: 1490	Whenever this happens 90% of the fourth dimension it's the USB risers. If not that then it's either overclocked style too high for the voltage. Bring back to stock for a while and test that mode. If it crashes then it's your risers.

xxcsu	Whenever this happens 90% of the fourth dimension it's the USB risers. If non that then it's either overclocked way as well loftier for the voltage. Bring back to stock for a while and exam that way. If it crashes then information technology's your risers. ... or mayhap the 94.four C gpu hot spot temp and the 91C avarage GPU HMB temp what the OP get on his cards ...

pablogv Newbie Offline Activity: 18 Merit: 0	Mounted a new rig this week and i was fked upwardly considering information technology was going downwards every hour more than or less. Later on some testing (risers, cables, power, psu,etc...) i came downward to check the basic and pulled off the reset connection at the ability jumpers. Running fine for 3 days at present PS: fekin asrock h81 its shit compared to asus mobos ^^

Geraldo Sr. Fellow member Offline Activity: 574 Merit: 272 ⭐⭐⭐⭐⭐	Are yous perform dual mining? Effort to lower the target temperature and increase max fan speed.

stonedgz Newbie Offline Activity: 84 Merit: 0	i accept the same trouble my rig restarts every few hours i dnt know why my power draw from gpu is 130 its besides much how can i lower the power consumption ?

digitalunix Newbie Offline Activeness: xviii Merit: 0	it is merely considering your psu is not enough for 4x vega 56. Try using three or 2 commencement, so sometime afterwards fourth one. But in whatsoever instance, problem is your psu, try to connect a higher one or get in dual psu.

minefewcoins Jr. Member Offline Activity: 34 Merit: 2

Cheers all for the reply. The power depict is measured with wattmeter, so it'southward the full draw from the wall (only I lowered the power limit). The trouble is that bill of fare is adjusting fan settings according to the gpu temperature and ignoring the others like HBM. I put manually to college RPM and everything was actually cool except HBM on max temp arround 80C. I guess I should undervolt it because it is one.25V stock. I am testing it once more and will study back in 10hrs or and then.

chandrarahmadewa Member Offline Activity: 308 Merit: 49

Hullo, this is my showtime post, so be gentle please. My PC restarts few minutes later on I start Claymore dual miner (eth-dcr). I tried to limit power draw anywhere from -xv% to -50%. It says my power draw from the wall is 700-1150w depending on settings. No matter what settings I put on Wattman it restarts every time. I tried 2-3  drivers and information technology didn't help. Can y'all point me in the right direction considering I am totally clueless? My rig is: PSU FSP aurum 1200w PT 4x Asus Vega Strix 56 CPU Pentium G4400 MOBO Gigabyte GA-H110-D3A Mining Ready RAM Crucial CT8G4DFD8213 SSD Kingston uv400 Riser bill of fare ver.008s Are you lot aware of the double performance mining VGA functioning becomes less than the maximum? Ameliorate focus on one mine with maximum results. Try to exercise ane mining, is there all the same frequently a restart? And practice not forget to see the temperature not to 80C, if using the application after burner immediately lower the memory clock and cadre clock.

minefewcoins Jr. Member Offline Activeness: 34 Merit: 2	I put fan on manual and it solved graphic cards problems. Simply where is this "Temperature iv" sensor on MOBO? Information technology goes over 93C

dimelight2 Newbie Offline Activity: nine Merit: 0	It can be windows update trouble if you are using windows, be sure you lot have turned of windows update.

minefewcoins Jr. Member Offline Action: 34 Merit: 2	It tin can exist windows update problem if yous are using windows, be sure you have turned of windows update. Information technology is disabled. Exercise yous know where could be that part so I tin can put better heatsink on it, or put one fan near it? Hither is the photograph of mobo

Lampaster Sr. Member Offline Activeness: 406 Merit: 255

Im pretty certain they shouldn't run hotter than 80C 80 degrees is a lot. I accept in the settings Claymore is off at 72 degrees. It is possible to switch-off rigs OP in the same range. I never let my GPU to work at temperatures to a higher place sixty degrees. Information technology is in dual style. It'southward cold in my country at present. Therefore, my rigs are non heated in a higher place 50 degrees. I think this is the best regime.

hunterlify1995.blogspot.com

Source: https://bitcointalk.org/index.php?topic=2930180.0

Share this post